MHS / Wiseco Gen 1/2 5.0L Coyote Competition Piston and Ring Kit- 3.630" Bore, -3cc Flat Top

This MHS / Wiseco Piston and Ring Kit is designed for competition use and capable of relabiably holding 2500+ HP and 45+ lbs of boost. These Pistons have many subtle upgrades and details that make them just plain work! 

Why 3.630" Bore? The Stock Bore is a good place to start with a sleeved engine block. This keeps the sleeves as thick as possible, and leaves plenty of room for future rebuilds. 

Why 10:1 Compression? It's a good compression ratio for high boost pressures. There is no need to go any higher, just to have to pull more timing. We have had extremely good success in the 10.0:1 - 10.5:1 Compression range on both Ethanol based fuels and Methanol. 

• 3.630" Bore
• -3cc Flat Top 
• Full Round 2618 Competition Forging 
• .300" Down Top Ring with Max Ring Land Spacing 
• Lateral Gas Porting for better Top Ring Seal 
• Internal Skirt and Undercrown Mill for Lightening 
• Ceramic Dome Thermal Barrier Coating 
• Spray on Moly Skirt Coating 
• Double Broached Pin Oilers 
• 2.500" x .230" Wall Tool Steel Wrist Pins 
• Double Spiral Locks 
• Wiseco GNX Rings - Nitrided Steel Top, Napier 2nd